Laser Etched

One of the things you learn when you have a small Miller Dynasty 200 a / cd / c Inverter TIG welder is how to do welding on thick aluminum castings with a low amperage to. I have the opportunity to work with two really popular Tig Welding Inverter had held that the Tig welding aluminum with 115V or 230V power, are capable of welding, the v205t Miller Dynasty 200dx and Lincoln Invertec. Both machines are high-quality energy sources, but both of these welding machines are limited to approximately 200 amps output. Beinglimited to 200 amps does not make you intelligent welding hotter. Instead of just setting the amperage to 275 and plowing ahead as you would on a heavy Tig Welding Machine, you must use your head. Preheat thick aluminum parts is a proven way to reduce the current needed to weld to. But if you are in your garage and have no access to a heat treatment furnace or oxy-fuel burner, as you see preheating? Well, here are a few tricks I've learned:

Use a gas grill. But ensure that the aluminum –Welded part contains nothing that harmful to go, the quality of burgers, you might want to cook next week. (It would be really a good idea to have dedicated a cheap grill to preheat aluminum parts)

Wrap the part in aluminum foil and place it on the stove over medium heat until the heat is a part. (Over a beer or two later part is hot enough to weld)

Use a small propane torch and keep moving until the part is hot enough. (Just hotenough to sizzle spit should be ok.)

Another tip for reducing the current to Tig welding aluminum is required to use a 50/50 or 80/20 Argon / helium gas mixture. The additional helium really makes a difference. Not only will you need less current, but the puddle of aluminum is faster and cleaner than with pure argon. Trust me on this one!

Finally, I would recommend that the smallest possible Tig cup as possible. Some people describe them as Tig welding nozzles in each case, however, is the ceramic that goes on topEnd of the TIG torch, that the inert gas to the weld head and protects the tungsten electrode from oxidation. With a small cup Tig requires less shielding. For example, a # 7 Goblet 15-20 cfh whereas requires a # 4 cup cfh requiring only 8-10. How much less gas bubbles on the part makes a big difference in the required amperage. In addition to this, that's the arc of energy dissipated in the form of cathodic etching (also known as cleaning action) will only go where itGas-shielded, so there is extra sheets available energy to focus on the weld puddle.

I reminded myself of all these tips just last night when I was a 4-inch welded processed ingot of 6061 aluminum with a Miller Dynasty 200 amps Tig welding inverter. I had some material, the investments were miscut by a workshop on a prototype part, which has replaced a lot of processing time. I have the exact welding tips that I mentioned earlier in this article: I put the part on the stove andexactly preheated to around 200 F (a beer). I have a 50-50 argon / helium mixture, and I have a 3 / 32 dia thorium electrode with a # 4 ceramic Tig nozzle. I was really surprised when I only had about 170 amps to do the job, even if the part was pretty solid.

Comments Off